Table of Contents
Advertisement
Accept. Otherwise the "No Programmers found" message will be displayed in the
table Search results and the button Accept is disabled.
If the search result is "No Programmers found", please try turning off the Stand-Alone
programmer using the menu "File / Shut down computer", then turn off the power
button on the back of the programmer, wait for 15 seconds or more and start the
programmer again. If the search result is still "No Programmers found", please refer to
the troubleshooting documentation.
Programmer / Connect Sites
This menu command starts the control applications for all available programmer sites.
The "Connecting Sites" indicator is displayed during connecting of the sites. Additional
information about the site connection progress is displayed for each site in the Status
panel on the main screen.
Programmer sites are numbered from #1 to #8 in the direction of physical placment of
sites from left to right.
When the connection process is complete the indicator "Connecting Sites" will be
hidden. The Status panel will contain information about each site. The following status
information are the most common:
• Ready
means the programmer site is connected and ready to start any
operation
• Present
special status of the connected site means the site is connected but it is
also not selected (checked in the dialog Select sites). The user
selected device or project operations will not run on Present
(unselected) sites. The user can set the site selection in the dialog
'Select sites' accessible through the menu command 'Programmer /
Select Enabled sites'.
• No project file is loaded – means the site is successfully connected but no project
file is loaded. It also means that no device is selected. The
recommended action is "Load project".
• other text
describes the current status of the site(s)
Programmer / Disconnect Sites
This menu command is used to disconnect all programmer sites and close the
Programmer sites control applications. The command will apply only if no device
operation is currently running on any of the connected sites. The command does not
close the main control program. The Stand-Alone programmer and computer remains
running.
Programmer / Automatic YES!...
This command displays the dialog "Site settings" with the Automatic YES! options.
30
Advertisement
Table of Contents
