Dataman -848PRO2 User Manual page 31

Three modes of Automatic YES! function are available:
• On
• Off
• Use Project settings
When Automatic YES! mode is On the programmers sites are scanning their device
sockets after each device operation is completed. The control program can detect
removal of the programmed device and insertion of a new device and afterwards
automatically start (repeat) the recent operation on the new device. The operator does
not need to press any key or button to program the next device.
When Automatic YES! mode is Off the operation on the next device can be started
manually by pressing the YES! button near each programmer site. Each programmer
site has its own YES! button.
The status of the active Automatic YES! function is displayed on the bottom left side of
the LCD main screen with the label Automatic YES! Is On:
If the Automatic YES! function is Off, no label indicating the Automatic YES! status is
displayed.
For more details about the Automatic YES! Feature, see the chapter on Programmer /
Automatic YES! .
Programmer / Select Enabled Sites...
This command displays the dialog "Select Enabled Sites".
Automatic YES! Is always On
Automatic YES! Is always Off
Automatic YES! setting depends on the relevant settings
set and stored in the project file
31