Table of Contents
Advertisement
Because Windows allows only one user to be connected at a time the following
message may be displayed.
Warning: Connecting to the programmer using the remote desktop sytem at a time
when devices are being programmed will cause any actions to be immediately
terminated – your devices may not be fully programmed. Please restart the computer
after you finish remotly administering the system.
Because working through the remote desktop is similar to working on local station
please continue to read the chapter "Local administration" for help on other features
and commands.
Local administration
For local administration of the Stand-Alone programmer you must have connected a
standard PS/2 keyboard, PS/2 mouse, and standard analog display with a resolution of
at least 1024x768 and 32bit color support.
The operating disk drive is divided into three volumes. The first volume is named
"Recovery" (C:) and contains software for the OS recovery which will return the
programmer to the state as shipped from Dataman. Standard start time of the
programmer is about 2 minutes. Should the programmer not start within 10 minutes it
may be necessary to perform the OS recovery. Before going through with the operating
system recovery please connect a monitor to the programmer and report what you see
to Dataman support. For the next steps please refer to the "Operating system
43
Advertisement
Table of Contents
