Exclusion And Re-Inclusion Of An Multifeeder Device; Control Of Temperature And Current Absorbed By Multifeeder - btsr MULTIFEEDER Operating Manual

3) Exclusion and Re-inclusion of an MULTIFEEDER Device

4) Control of Temperature and Current Absorbed by MULTIFEEDER

- 3-4 -
When needed, it is possible to temporarily exclude an MULTIFEEDER device, in
order to avoid undesired starts due to vibrations, etc. To exclude and re-include a
device, operate as follows:
Exclusion:
Press and hold down for 3 seconds
The display will show the exclusion confirmation request.
to confirm the exclusion .
to cancel the operation .
The <<OFF>> indication, shown on display indicates that the device
is currently excluded.
Re-inclusion:
To re-activate the device press and hold down for 3 seconds
to confirm the re-inclusion .
to cancel the operation .
In order to temporarily de-activate an MULTIFEEDER device, simply press
. The condition of device temporarily de-activated is signaled by the
lighting of the two red LEDs on the device, by the lighting of the red LEDs on
the three device's buttons and by the lighting of the Stop Led on KTF/PW4
device.
At any time, pressing the
of the control board (42°C in the example below) and of the motor (36°C in the
example below), as well as the current absorbed by the motor (C) in Ampere (0.3 A
in the example below).
MULTIFEEDER
, button, you can check the internal temperature (T)
Operation
:
.