Installing The Lens - Christie CP2309-RGB Installation And Setup Manual

A MAIN input plug
B IN-LINE receptacle
C UPS input plug
6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Reinstall the rear panel of the projector.
8. Reinstall the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. Remove the lens surround.
2. On the front of the projector, unlock the lens assembly with a hex key.
CP2309-RGB Installation and Setup Guide
020-103078-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installing and setting up
20