Description Of Menu-Network Functions - Ikegami HQLM-1720WR Operation Manual

4-14 Description of MENU-NETWORK Functions

REMOTE number
Set the ID number for the optional serial remote
controller, "SRC-400," and the IR remote controller,
"RCT-30A" from 01 through 99.
Set the ID number which is used during the remote
control in the network from 01 through 99.
Default setting is 01.
Setting of the monitor ID number for TSL 4K
MODE/2K MODE
Set the monitor ID number of the TSL control using
RS485 in 4K MODE and 2K MODE for VIEW
MODE.
No. "0 to 126" is available for setting the ID num-
ber.
The number of units which can be driven by the
chain connection is up to 32 units per line. However,
up to 126 units can be controlled individually by
increasing the number of lines.
Default setting is 000.
Setting of the monitor ID number for TSL
MULTI MODE
When the VIEW MODE is MULTI MODE, the TSL
control ID number of each of the four screen areas
divided is set by the following items
No. "0 to 126" is available for setting the ID number.
The number of units which can be driven by the
chain connection is up to 32 units per line. However,
up to 126 units can be controlled individually by
increasing the number of lines.
TSL MONITOR ID LT setting
Set the TSL ID number at the upper left screen.
Default setting is 000.
TSL MONITOR ID RT setting
Set the TSL ID number at the upper right screen.
TSL MONITOR ID LB setting
Set the TSL ID number at the lower left screen.
TSL MONITOR ID RB setting
Set the TSL ID number at the lower right screen.
IPV4 SETTING setting
Following items
setting of Ethernet network.
IP ADDRESS setting
Example 192.168.1.100
SUBNET MASK setting
Example 255.255.255.0
DEFAULT GATEWAY setting
Example 1192.168.1.1
SPEED / DUPLEX setting
Setting of communication method
AUTO, 100M FULL, 100M HALF
through .
- -
45
HQLM-1720WR
through are used for the