Data 2 Parallel Remote Pin Functions - Ikegami HQLM-1720WR Operation Manual

HQLM-1720WR

Data 2 Parallel Remote Pin Functions

Connector Face View on Rear Panel
<Connector on system side>
D-Sub 15-pin (male) mini-type
*Connector
CD0115PA100: CVILUX-made
*Case
DE-C8-J9-F2-1: Japan Aviation
Electronics Industry-made
*The above parts or equivalents are
supplied as standard.
* Notes: Remote control terminals should only be controlled by "short circuit to GND pin" or "open" and not
control voltage.
Application of voltage may cause failure.
Pin functions by default
Pin No. Function
1 GND
2 V-4K-CH-B1 on
3 NC
4 G TALLY on
5 NC
6 CHROMA UP on
7 MONO on
8 NC
9 NC
10 NC
11 NC
12 MARKER on
13 SHADOW on
14 R TALLY on
15 V-4K-CH-A1 on
* Functions explained in this table can be allocated to any pins in the same way as the user setting function in
the next section.
Wiring of Remote Connector (by default)
GND
V:4K-CH-B1 on
NC
G TALLY on
NC
CHROMA UP on 6
MONO on
NC
NC
NC
NC
MARKER on
SHADOW on
R TALLY on
V:4K-CH-A1 on
External Assignment for Function
Connecting remote terminals to this pin enables ON control.
Connect to Pin 1 to switch the input (4K mode) setting to CH-B1 (12G-SDI).
No connection
Connect to Pin 1 to set G TALLY to ON.
No connection
Connect to Pin 1 to set CHROMA GAIN UP function to ON.
Connect to Pin 1 to switch the COLOR/MONO setting to MONO.
No connection
No connection
No connection
No connection
Connect to Pin 1 to set MARKER to ON.
Connect to Pin 1 to set SHADOW to ON.
* The shadow is displayed in the "MENU-MARKER" -preset level.
Connect to Pin 1 to set Red TALLY to ON.
Connect to Pin 1 to switch the input (4K mode) setting to CH-A1 (12G-SDI).
- 66 -
1
2
3
4
5
7
8
9
10
11
12
13
14
15