Table of Contents
Advertisement
2K MODE SDI-B4 SELECT setting
When DISABLE is set, CH-B4 is skipped by transition
of the front INPUT switch.
Default is ENABLE.
2K MODE HDMI SELECT setting
When DISABLE is set, HDMI is skipped by transition
of the front INPUT switch.
Default is ENABLE.
SDI STRUCTURE setting
When an SDI signal without the payload information
is input, the image may not be displayed properly
since the necessary information is missing. In that
case, the format of input signal has to be set. Select
from a combination of the signal format (RGB/YCbCr),
sampling structure (422/444), and bit width (10 bit/12
bit).
AUTO
: Automatic selection
YCbCr422/10 : 422 color difference signal 10 bit
YCbCr444/10 : 444 color difference signal 10 bit
YCbCr444/12 : 444 color difference signal 12 bit
RGB444/10
: 444 RGB signal 10 bit
RGB444/12
: 444 RGB signal 12 bit
In addition to this setting, the setting of
RANGE might be necessary.
Default is AUTO.
When there is no payload information in AUTO,
processing of YCbCr422/10 is conducted.
If SDI STRUCTURE is set to AUTO when the payload
information is incorrect for the image, "Image not
output / Menu not displayed / Menu flickering" may
occur.
In this case, press the TEST switch and with the in-
ternal TEST signal being displayed, set the SDI
STRUCTURE to match the input image.
When VIEW MODE is set to 4K MODE and if an
image judged to be 4K PsF format is input, the image
will only be output with SDI STRUCTURE is set to
AUTO. Settings other than AUTO will judge it as
NoSync and the operation will not output the image.
SDI RANGE setting
When an SDI signal without the payload information
is input, the image may not be displayed properly
since the necessary information is missing. In that
case, the following signal range setting may be re-
quired in addition to
AUTO
LIMITED
SDI FULL
Default is AUTO.
When there is no payload information in AUTO, pro-
cessing of LIMITED is conducted.
HDMI (DVI) FORMAT setting
When the DVI signal 2K/HD is input to the HDMI
input terminal, specify RGB or YPbPr here, since the
DVI signal does not have RGB/YPbPr information.
Default is RGB.
INPUT LOCK setting
When preventing the switching of the input channel,
set to "ON" to fix the input channel.
Default is OFF.
MIX TEST SIGNAL
SDI
EXECUTE
MIX TEST SIGNAL is displayed.
While MIX TEST SIGNAL is displayed, executing
EXCUTE again hides the MIX TEST SIGNAL.
In addition, it becomes hidden after one minute from
the first display.
- -
15
HQLM-1720WR
SDI STRUCTURE setting.
: Automatic selection
64 to 940 (bit width when 10 bit)
: 4 to 1019 (bit width when 10 bit)
Advertisement
Table of Contents
