Ikegami HQLM-1720WR Operation Manual page 16

HQLM-1720WR
AUDIO control
21
Use this control to adjust the sound volume of
the front speaker or the headphones.
* The embedded audio channel to output from the
speaker is set from "MENU - AUDIO - LINE/SP
CH".
* If you input an audio signal of -10 dBFS or more
with embedded audio, distortion will occur even
if you lower the audio volume.
Especially in continuous sound of -10 dBFS or
more, the sound has distortion.
* Distortion may occur when the audio volume is
used at max.
OVER RANGE indicator
22
OVER RANGE increases the contrast or brightness
with high brightness signal. If it exceeds the dynamic
range of the signal processing circuit, the LED lights
.
up
Please reduce the contrast or brightness to use.
If both the ABL and OVER RANGE are operated,
the LED flashes quickly (approx. 0.25 sec. inter-
val)
Infrared receiver of wireless remote control
23
When a wireless remote controller (RCT-20A/
RCT-30A) is used, point it towards this receiver.
Stereo headphones output (stereo mini-jack
24
type)
Analog audio signals, embedded audio signals
and downmix audio signals are fed out of this
terminal.
The analog and embedded inputs can be selected
in MENU-AUDIO-LINE/SP CH.
*
If you are using a sound isolating headphone,
some residual sound may be heard even when
the sound volume is set to minimus.
USB terminal
25
Connect a USB memory, and the monitor's data
("MENU setting," "PRESET data setting," and
"USER MARKER setting") can be saved on the
USB memory or the data on the USB memory can
be downloaded to another monitor.
* It is possible some memory devices do not work
in the USB memory slot of the monitor, please
try another memory in that case.
Connect a USB mouse, and the user markers
can be drawn.
Speakers
26
Analog audio signals, embedded audio signals
and downmix audio signals are fed to the
speakers.
The analog and embedded inputs can be selected
in "MENU-AUDIO-LINE/SP CH".
With the headphones being connected, no sound
is heard from the speakers.
- 6 -