Basic Menu - RadioLink T8FB Instruction Manual

SAVE The data read or set will be saved as TXT file in the computer. This is very helpful if there are several
sets of radio data need to be saved or if one set of parameters need to be copied in different radios.
Parameters Setting Steps
When parameters need to be modified, click READ first to input the original data into the software, then

modify as wish and click UPDATE to output the modified data to T8FB.
When parameters SAVE as TXT file need to be input, click LOAD first to input the saved data into the

software then click UPDATE to copy them to T8FB.

4.2.1 BASIC MENU

There are 6 parameters to setup: "REVERSE""SUB-TRIM""END POINT""FAIL SAFE""AUX-CH""DELAY"
REVERSE: Defines the relationship between the transmitter controls and the receiver output for channels
with option of NORM and REV. Refer to 3.4.2-REV (P11) for more details .
SUB-TRIM: Makes small changes or corrections to the neutral position of each servo. Refer to 3.4.2-SUB
(P11) for more details .
END POINT: Sets the range of each channel(in percentage);
The most flexible version of travel adjustment is available. It independently adjusts each end of each
individual servo's travel, rather than one setting for the servo affecting both directions. Refer to 3.4.2-EPA-L
&EPA-R (P12) for more details .
FAIL SAFE: Sets responsive action of model in case of signal loss or low Rx voltage(in percentage).
Refer to 3.4.2-F/S (P12) for more details .
18
RadioLink Electronic Ltd
www.radiolink.com