Table of Contents
Advertisement
HNC 47.82
9.4
Dust extraction
Adjust the extraction
Connection to the dust extraction system
Fig. 20: Dust extraction
1
Connection for dust extractor (Ø 32 mm)
2
Height adjustment extraction
3
Extraction/cable guides
CAUTION
Breathing in dust
Risk of damage to health from dust
−
The machine may only be used in combination with a func-
tioning extraction system.
Assembly see ⮫ Chapter 8.6 'Mount the extraction hood' on page 29
●
Check before running for the first time, or after any significant changes that
the air speed complies with the requirements.
●
The dust extraction setup must be checked before the machine is put into
operation for the first time. Check for obvious defects on a daily basis and
the efficiency on a monthly basis.
●
The dust extraction hose must be electroconductive and grounded to prevent
electrostatic build up.
●
Use extraction with reduced dust emission to clean dust from the machine.
1.
Release the height adjustment screws for the extraction.
2.
Set the extraction hood in such way, that the dust brush is positioned several
millimetres above the tool.
3.
Tighten the height adjustment for the extraction in place.
1.
Connect the extraction pipe to the machine extraction socket. Use hose
clamps if necessary.
3
2
Adjustments and tool changes
1
39
Advertisement
Table of Contents
