Tighten The Router Motor In Place - Felder Hammer HNC 47.82 Translation Of The Original Operating Instructions

HNC 47.82
9.2

Tighten the router motor in place

Fig. 17: Tighten the router motor in place
1 Fixation of the router motor
2 Mains connection router motor (rear side)
3 Extraction/cable guides
1.
Place the router motor in to the 43 mm collar and clamp using the nut
(10-11 Nm).
2.
Connect the power cable and rotation speed control (optional) to the Z-axis.
3.
Fix the cable using cable ties to the mount on the Z axis.
4.
Set the height of the extraction hood. The end of the brush must be at the
same height of the tip of the router.
Adjustments and tool changes
2
3
1
35