Table of Contents
Advertisement
Setup and installation
8.7
Electrical connection
Overview
30
WARNING
Electric current!
Serious injury or death
−
The work to be performed may only be carried out by a
trained electrician.
Before connecting the machine to the power supply, compare the information on
the nameplate with those of the power supply. Only connect the machine if the
two sets of data correspond to each other. The electrical outlet must have the
appropriate socket. It is prohibited to open the electrical box on the machine
without the express authorization from the Hammer Service Department. Violating
this stipulation renders any guarantee rights invalid.
NOTICE
Incorrect mains frequency
Damage to the HF spindle
−
The HF spindle must always have a 230 Volt supply. If neces-
sary, a frequency converter must be used.
NOTICE
Connecting / removing accessories
Material damage
−
Before connecting or removing accessories, the machine must
be switched off.
Before connecting or removing accessories:
1.
Switch the machine off at the main switch.
2.
Disconnect the power cable from the machine.
1
Fig. 12: Machine connections at the front
1
PC-Port (25 Pin)
2
Emergency stop
3
Tool length measurement system
4
4th axis
5
AUX-Port
2
3
4
5
Advertisement
Table of Contents
