Remove Transport Locking Devices; Setup - Felder Hammer HNC 47.82 Translation Of The Original Operating Instructions

HNC 47.82
8.3

Remove transport locking devices

8.4

Setup

Requirements
It is recommended to store the packaging and transport locks,
once removed. If, due to any defects, the machine has to be
returned to the manufacturer then the original packaging and
transport locks should be used.
1
Fig. 9: Transport locking device
1 Pallet transport locking devices
2 Machine transport locking devices
The machine is attached to the pallet with 2 transport brackets.
Tool:
●Screwdriver with star bit T30
1.
Remove the transport locking devices from the pallet.
2.
Lift the machine off the transport pallet.
3.
Tilt the machine upwards and remove the transport brackets from the
machine.
●
Operating/room temperature: +10°C bis +40°C
●
Sufficiently stable and proper load-bearing capacity of the work surface.
Instable work surfaces create safety risks. And they can also lead to stop-
page of the machine.
2
Setup and installation
27