First Cleaning; Time Setting; Schedule Cleaning - Tesla RoboStar T10 Manual

8. The vacuum cleaner starts cleaning automatically until the battery is almost empty, then the
vacuum cleaner automatically searches for the charging station and starts charging the
battery.
9. To pause/stop the vacuum cleaner operation, press the "CLEAN" button again.
10. Press and hold the "CLEAN" button on the vacuum cleaner for 3 seconds to switch the device
into the "Standby" mode.
11. The vacuum cleaner also switches to the "Standby" mode automatically when it is idle for
more than 10 minutes.

FIRST CLEANING

 Remove all obstacles that can prevent effective cleaning.
 Also remove objects that can damage the robotic vacuum cleaner.
 The carpet must be secured so the robot cannot get on it when mopping.
 Direct sunlight may cause a reduced sensitivity of the infrared sensors of the vacuum cleaner,
please avoid direct sunlight light.

Black furniture may not be properly detected due to the physical nature of infrared sensors.
This may cause a slight impact, which will be reduced by the front bumper.

TIME SETTING


Press the "CLOCK" button on the remote control to enter the "Time Setting" mode, use the
directional buttons to adjust the time (HH: MM).
 Press the "CLOCK" button again to confirm and save the set time.

Successful time setting will be confirmed by a beep sound on the vacuum cleaner.

SCHEDULE CLEANING

 The vacuum cleaner will always start cleaning at the set time.
 Press the "PLAN" button on the remote control to enter the "Schedule Cleaning" mode.
 Use the directional buttons at the top half of the remote control display (HH: MM) to set the
start for the schedule cleaning.

Press the "PLAN" button again to confirm the set time of the "Schedule Cleaning".
 To erase the set time, turn the vacuum cleaner off (the main on/off switch).

Successful schedule cleaning setting will be confirmed by a beep sound on the vacuum
cleaner.