First Start - Tesla RoboStar iQ300 Manual

4. Place the vacuum cleaner in the charging station and the vacuum cleaner battery will start
charging automatically.

FIRST START

SMART CLEANING
1. This is the most commonly used method of cleaning. The device uses advanced gyro
navigation and moves along a cleaning route that is optimized for the best possible floor cleaning.
2. Switch on the robotic vacuum cleaner by switching the „Main power switch ( 3)".
4. The
fully charged.
5. Press „Control button (2)" or press on the remote control button „2" or „3".
The vacuum cleaner should always be in the charging station when cleaning is started.
6. To stop cleaning/pause the robotic vacuum cleaner, press
remote control button „3".
SPOT CLEANING
Place the robotic vacuum cleaner at the location you want to clean and select in the mobile app „Spot
cleaning".
SMART CLEANING WITH MAXIMUM PERFORMANCE
Press the button on the remote control. The robotic vacuum cleaner starts SMART cleaning with
maximum suction power.
TIME SETTING
Press the button
buttons ˄ and ˅. Then press > and set the minutes in the same way. Confirm the set values by pressing
.
SCHEDULED CLEANING
The robotic vacuum cleaner can be programmed to clean automatically once a day at a specified time,
even when no one is home.
Press the button
and set the minutes in the same way. Confirm the set values by pressing
cleaner will vacuum every day at the time you set. To cancel the scheduled cleaning , press the button
3.
button flashes slowly while charging, this button stops flashing when the battery is
on the remote control to enter the „Time Setting" mode. First set the hour with the
on the remote control. First set the hour with the buttons ˄ and ˅. Then press >
Turn on: set the switch button to the
position ON ( I )
Turn off: set the switch button to the
o
position OFF ( )
button or press on the
. The robotic vacuum