Table of Contents
Advertisement
4 ACCEPTANCE/PERIODIC TESTS
7. At the Parity prompt, select None and press TAB.
8. At the Phone Number and Auxiliary Phone fields, press TAB and leave blank.
9. At the Switch Code prompt, press TAB.
10. The Break Signal feature should be de-selected and Duration of Break set to 0 seconds. Refer to Sec-
tion 11.4: SETTING UP YOUR HOST MACHINE on page 11–11 for more details.
The Unit Description for TEST is complete. Select OK and Close to finish.
f) RELAY SETUP
Before shipment, the relay is set with factory default settings. These include the Unit ID, the Baud Rate, and
the Factory Passwords. The default communications parameters are listed in Table 4–2: FACTORY DEFAULT
COMMUNICATIONS PARAMETERS below.
Table 4–2: FACTORY DEFAULT COMMUNICATIONS PARAMETERS
Parameter
Unit ID
View Password
Control Password
Settings Password
Master Password
Baud Rate
g) LOGGING INTO THE RELAY
1. Select Connect from the Device menu.
2. Select the TEST device just created. LPSO-Link will prompt for a password. If this is the relay login, the
passwords listed in Table 4–2: FACTORY DEFAULT COMMUNICATIONS PARAMETERS must be
changed before any relay functions except CHANGE PASSWORD and LOGOUT will operate. See Section
11.7.4: CHANGE PASSWORD on page 11–21 for details on changing a password with LPSO-Link.
3. Type in the current Master password and click OK. If the password is not known, refer to Chapter 8.2.8:
COMMUNICATION PASSWORDS on page 8–23 for details on displaying the current password.
4. At this point, LPSO-Link responds with a complete display of menus. If this was an initial login, you must
first change the password and then log out and log in again in order to get a complete display of all the
menus.
5. Select Logout from the Device menu.
6. Select Yes to logout.
h) SETTING CHANGES
Setting changes required for a particular test are listed before the test. A setting can be changed either by cat-
egory or individually, by selecting either Device > Settings or Device > Local Settings from the LPSO-Link
menu bar. A procedure for and example of how to change settings with LPSO-Link is provided in Section 11.6:
SETTINGS on page 11–18.
GE Power Management
Setting
0
VIEW!
CONTROL!
SETTING!
MASTER!
9600
LPS-O Line Protection System
4.1 OVERVIEW
4
4-
7
Advertisement
Table of Contents
