10.6 TOOLS MENU
10.6 TOOLS MENU
There is one menu item Setup. Click on Setup and the following dialog box is displayed.
The Remove button and the Command line and Menu text boxes are disabled, and that the focus is set to
the Add button.
Type the Enter key or click on the Add button. The Add Tool dialog box is displayed. This is a standard MS-
Windows dialog box. Select an executable windows program and click on the OK button.
•
The full path and name is in the Command line text box
•
The program name less the extension is in the Menu text box
•
The program name less the extension is the Menu contents list box
•
The Remove button is enabled
•
The focus is set to the Menu text box.
Change the text in the Menu text box to text suitable for the tools menu. Click anywhere in the Command line
text box.
•
Verify that the new menu name is displayed in the Menu contents list box.
Change the command line so that it is invalid (for example, remove a character from the program name). Click
on the OK button. Pull down the Tools menu.
Verify the following:
•
There is one tool followed by a separator bar and the Setup menu item.
•
The tool's name is correct.
Click on the tool.
•
Verify that an error message is displayed indicating that the program couldn't be started.
10
Select the Setup menu item again.
10-
14
Figure 10–16: TOOL SETUP DIALOG BOX
LPS-O Line Protection System
10 ALPS-TEST PROGRAM
10.6.1 DESCRIPTION
GE Power Management