GE LPS-O Instruction Manual page 228

11.2 LPSO-LINK INSTALLATION
11.2 LPSO-LINK INSTALLATION
11
This section describes the required system hardware and software needed for installing LPSO-Link software
on your machine.
The minimum system configuration required to run LPSO-Link software is:
Personal Computer (PC) with an Intel 80386 or better processor with:
• 8 MB RAM
• minimum 200 MB of free Hard Disk space
• CD-ROM if using GE Products CD
• VGA / EGA or better display card and monitor
• PC/AT keyboard
• One or more RS-232 serial ports
• One parallel port for printer
• Mouse
• Any printer supported by Microsoft Windows
• Windows 95, Windows 98, Windows NT, Windows 3.1
The LPS-O relays can be connected to the host machine directly or through a dial-up modem. The LPS-O may
be connected directly to the hosts RS232 port; for connection via the LPS-O RS485 port, an RS485/RS232
converter is required. If you wish to connect to your LPS-O over a dial-up modem, the relays should be con-
nected as follows:
• Each device must have its own modem.
• A Code Operated Switch (COS) is attached to the modem and a number of devices are connected to the
multiplexor. If a device is on an RS485 line, a converter can be used between the device and the COS.
The printer is connected to the parallel port of the PC.
11-
2
LPS-O Line Protection System
11 LPSO-LINK USER GUIDE
11.2.1 DESCRIPTION
11.2.2 SUPPORTED ARCHITECTURE
GE Power Management