GE LPS-O Instruction Manual page 251

11 LPSO-LINK USER GUIDE
With Demand Report it is necessary to select the demand number (or range) for which you want demand
data. Normally the allowed range is 1 to 192. If Extended Demand Option is set, then the valid range is 1 to
3360. If you want to see the report for a particular number and not the range, enter the same value in both the
Start Interval and End Interval entries.
Select Diagnostics from the Report menu to see a listing of all the diagnostic events occurred at the device.
Select Event from the Report menu to see the events data fetched from a connected device.
When you select Present Values from the Report menu, LPSO-Link will pop-up a dialog box asking you to
enter the period value in seconds. LPSO-Link will monitor the present values and update these values at the
end of specified period continuously. These updated values are displayed through a special dialog box where
you can monitor these as long as you want. You can get a report of these values at any moment by selecting
the Generate Report option or stop monitoring by selecting Close option on the special dialog box monitoring
these values.
NOTE: When General Setting 108: DISPLAYVAL= PRI (set to primary), the current values are in amps
and the voltage values are in kV. The LPSO-Link Present Value display will show the units as V.
Select Status from the Report menu to get the status report of various system components.
Select Contact Status from the Report menu to get the status of various contacts associated with the device.
The status is conveyed in the On/Off or Open/Close terminology.
Select LUI Password to get a report on passwords of all the three levels namely settings level, control level
and master level.
This helps you view and/or print a report stored in a file. The report must have been fetched earlier from the
device and stored in the file. When you choose the Open item in the Report menu, a File Open dialog box
appears.
In the File Open dialog box, the File header part displays some information about the report file you are open-
ing. This helps you in picking the right report file. Select the file name, directory and the source from where you
want to read the report. The report will be displayed and you can print the report.
GE Power Management LPS-O Line Protection System
11.8 INFORMATION
11.8.7 DEMAND REPORT
11.8.8 DIAGNOSTICS REPORT
11.8.9 EVENT REPORT
11.8.10 PRESENT VALUES REPORT
11.8.11 STATUS REPORT
11.8.12 CONTACT STATUS REPORT
11.8.13 LUI PASSWORD REPORT
11.8.14 OPEN REPORT
11
11-
25