Table of Contents
Advertisement
DN-60 Powering On
Connect the DN-60's own power adaptor to the right hand side DC In socket.
Ensure the power adaptor unit is connected to a suitable mains socket. Switch
the power ON/OFF switch on the Left hand side of the unit to one of 3 positions.
1.
Manual power ON position
A.
Auto power ON/OFF position (DV port button is switched on/off)
0.
Manual power OFF position
DN-60 Status LED and Error Messages
The DN-60 has a red status LED just below the Menu Navigation Button. This can be used as a quick way of
confirming that the unit is working correctly or is requiring user attention.
LED constantly ON – Indicates the DN-60 unit is recording a camera/source input.
LED constantly OFF – DN-60 is idle or the unit is waiting to be powered on.
LED Slowly Dimmed OFF and ON – Indicates record pause, formatting card, or making media file.
LED Flashing ON and OFF – The LCD panel will also indicate that there is:
No Media
No Input
Bad Input
Unsafe Battery level
Wrong Format Media!! - CF card does not match the format settings of the DN-60.
User can choose
DN-60 Menu Navigation
Pressing the Navigation Button in will select the menu option or confirm a value. Rotating the Navigation Button in
either direction will change the menu option or set a value. If all options have been displayed then the menu
display will only scroll options in one direction. Choose EXIT to return to a previous menu level or to return to the
initial Home screen (shown below).
The DN-60 is a menu driven unit; there are several menus which are used to set up the unit. The menu settings
are non-volatile (settings are stored even when the unit is switched off). So general settings, such as Signal and
File types, will only need to be set once.
A brief overview of the DN-60 menu options follows. A full PDF version of the DN-60 manual can be obtained
from your dealer or local Datavideo office.
The LCD display panel will show "Datavideo DN-60 Loading..." after a few seconds the
Home Display will be shown. The DN-60 is now ready for set up or use as a recorder
or playback device.
- CF card is not detected by DN-60. Check CF card.
- Video signal is lost from DN-60. Check cabling and source equipment.
- Video signal received does not match the DN-60 settings.
- usually indicates low battery level. Change batteries or power source.
"RESTORE SETTING": Reset DN-60 configuration to accept the CF card inserted.
Or
"FORMAT MEDIA": Format the CF card according to current DN-60 configuration.
Caution: All content on the CF card will be erased by selecting "FORMAT MEDIA"
21
Advertisement
Table of Contents
