Hs-550 Dv Port Set Up; Dn-60 - A Brief Set Up Guide; Dn-60 Connections & Controls; Front Panel - Datavideo HS-550 Manual

Hand carry studio
Table of Contents

Advertisement

HS-550 DV port Set Up

The HS-550 has 2x DV / IEEE-1394 ports, one on the rear plate for connection to a DV deck, Camera or
Computer and one dedicated for seating a Datavideo DN-60 recorder to the left of the HS-550 mixer area.
In order to record from the HS-550 using these DV / IEEE-1394 ports the Button (labelled A) on the previous page
needs to illuminated Red. Once active these ports will send DV25 signals to the connected equipment. If the
button is off (not illuminated) then the DN-60 port will accept playback of recorded clips from the connected DN-60.
These clips can be viewed by switching the Program Monitor on the HS-550 to the V2 position. Remember to
return the HS-550 monitor and DV port button back to their original settings before attempting to mix/record again.
It is not possible to play 2 DV devices into the HS-550 at the same time this will only cause the external devices to
become un-responsive as they are both trying to access the same channel.

DN-60 - A brief Set Up guide

The DN-60 is not supplied with the HS-550. What follows is a brief outline of how to use the DN-60 to record from
the HS-550. A full PDF version of the DN-60 manual can be obtained from your dealer or local Datavideo office.
The DN-60 records the mixed Program output, video and audio, from the HS-550 via the DV / IEEE-1394 port on
the HS-550 top panel. This port needs to be seated correctly with the DN-60 in order for the signals to be received
properly.
When connected, the HS-550 does not supply power to the DN-60. Instead the DN-60 still needs to be powered
from internal batteries or its own power adaptor. The DN-60 should be switched on after being attached to the
HS-550.
DN-60 Connections & Controls

Front Panel

LCD Panel – Shows the status and menu options of the DN-60
1.
Menu Navigation Button – Rotate to change options and press in to select
2.
DC Power input – Connect the DN-60 power adaptor here
3.
4.
Status LED
5.
Power On / Auto / Off switch
CF Card Protection Cover – Slide down then lift up carefully to gain access
6.
19

Advertisement

Table of Contents
loading

Table of Contents