Powering On; Powering Off; Packing Away; Dimensions - Datavideo MS-3200 Instruction Manual

Each product built into this Mobile Video Studio receives DC power from PD-2A on the rear of the MS-3200.
Please ensure PD-2A is fed with either an AC or DC feed before attempting to switch on the MS-3200.
For more information about the PD-2A please refer to its manual in the binder.
If a product within the MS-3200 fails to start after the PD-2A is switched on please locate the on/off switch for
that product which has not yet started.
For further advice on using a product within the MS-3200 please refer to its manual on the respective product
page.
Before powering off the MS-3200 via the PD-2A on/off switch please ensure the HDR-90 has been stopped.
Once the external source and camera cabling have been removed from the rear connection plates replace
and secure the rear case cover.
Return the ITC-300 gooseneck mic, any ITC-300 cabling, tally lights and headsets etc to your accessory kit
bag/box.
Carefully lower the 17" TLM-170VM monitor and slide it back into its horizontal 1U shipping position. Please
remember to secure the silver screws so it cannot slide/move when in transit.
Now raise/tilt upwards the SE-3200 Control Panel Keyboard and secure it in its shipping position with the
chained securing bolts.
Now return and secure the front cover and the MS-3200 is ready to be moved.
Height
Width
Depth
All dimensions in mm.

Powering On

Powering Off

Packing Away

Dimensions

800
670
620
10