Powering On; Powering Off; Packing Away - Datavideo MS-2800A Instruction Manual

Powering On

Each product built into this Mobile Video Studio receives DC power from the PD-2A unit on the rear of the
MS-2800.
Please ensure the PD-2A is fed with either an AC or DC feed before attempting to switch on the MS-2800.
For more information on the PD-2A please refer to its manual in the binder.
If a product within the MS-2800 fails to start after the PD-2A is switched on please locate the on/off switch for
that product which has not yet started.
For further advice on using a product within the MS-2800 please refer to its manual in the binder.

Powering Off

Before powering off the MS-900 via the PD-2A on/off switch please ensure the DN-500 has been stopped.

Packing Away

Once the external source and camera cabling have been removed from the rear connection plates replace
and secure the rear case cover.
Return the ITC-100 gooseneck mic, any ITC-100 cabling, tally lights and headsets etc to your accessory kit
bag/box.
Carefully lower the 17" TLM-170HM monitor and slide it back into its horizontal 1U shipping position. Please
remember to secure the silver screws so it cannot slide/move when in transit.
Now raise/tilt upwards the SE-2800 Control Panel Keyboard and secure it in its shipping position with the
chained securing bolts.
Now return and secure the front cover and the MS-2800 is ready to be moved.
10