Call Request In Pabx Mode; Call From Telephone To Intercom System - Commend C-G8-TEL Product Manual

PABX Mode
Including a Range of Numbers via Wildcards
To simplify the configuration in CCT 800
numbers as "wildcards".
The telephone numbers included by those wildcards can then be dialled at the Intercom stations as
explained above.
Example:
PA-Code in CCT 800
4***
63**
345*
5*
Attention:
Observe collisions with Intercom call numbers and function codes (i.e. in case of a defined range of
"2***", e.g. the Intercom call number "210" can not be dialled)!
Cancel Conversation
The conversation is cancelled at the telephone with "#" or at the Intercom station with X.
In order that a phone call initiated by dialling the interface manually, can be cancelled at the
telephone with "#", the function
configured.
When an outgoing conversation is cancelled (via "#" or X), the connection to the Intercom system
will be cancelled immediately (contrary to incoming calls
If the telephone only hangs up and does not press "#", the conversation is automatically cancelled
after about 6 seconds.

Call Request in PABX Mode

For call requests / input messages it is possible to combine the auto dialler mode with the PABX mode.
This means, at initiation of a call request / input message automatically a switch-over to
Mode" is initiated – this also means, that the respective features of this mode will then become ef-
fective see page 11.
In spite of that feature, a phone call can still be built up as described at
Intercom System".

Call from Telephone to Intercom System

Note:
In case of calls from a telephone to the Intercom system, the location message and, if configured, in-
dividual messages are switched on at the telephone (same as in auto dialler mode).
Initiate Call
same as in auto dialler mode
Cancel Conversation
same as in auto dialler mode
26
(see page
Dialable Telephone Numbers
4000 – 4999
6300 – 6399
3450 – 3459
50 – 59
"After Dialling at Telephone – Outgoing Phone Call"
see page 14.
see page 14.
25), it is possible to define a range of telephone
*
see page 14).
„Outgoing Phone Call from
G8-TEL, G3-TEL
has to be
„Auto Dialler
1.0/0609