Outgoing Call From Intercom System - Commend C-G8-TEL Product Manual

G8-TEL, G3-TEL

Outgoing Call from Intercom System

Initiate call
For an outgoing call in the auto dialler mode, 2 different possibilities are available:
Call via dialling Interface
Dailling the call number of the telephone interface, i.e. of the G3-TEL/G8-TEL at the Intercom
station
Call Requests/Input Messages
For the telephone interface the "control desk function" is configured:
A call request is initiated at the Intercom station
An input message is initiated via an input
As soon as the call is set up, the 1st number in the currently selected dialling sequence is dialled.
Note:
At "Call Procedures – Examples" on page 13
ling the interface call number and a call request.
Switch-on of Speech Messages
As information for the calling Intercom station and for the telephone different speech messages are
switched on, after initiation of a call:
Messages at Intercom Station
Calm down message
The calling Intercom station receives this message (e.g. "you will be immediately connected to an
emergency station") as soon as the call is initiated.
The message is repeated until the call is taken over by the telephone.
Messages at the Telephone
Location message
The telephone receives the location message after lifting the receiver as information where (i.e.
from which telephone interface) the call comes from. This message should be recorded indivi-
dually (e.g.: "Parking North").
Call request message
If the initiated call is a call request, the telephone receives the call request message as information
on how many calls are waiting (e.g. "Calls: one, Emergency calls: three").
Individual message (optional)
For additional information, individual messages for the telephone can be defined separately for
each call mode (conversation, call or emergency call – e.g. "Call from station one–zero–five").
Note:
For general information to speech messages, see
"Speech Storage" on page 18
"Pre-Recorded Audio for Speech Storage" on page 21
1.0/0609
you will find a comparison between a call built up by dial-
Auto Dialler Mode
11