Call From Telephone To Intercom System; Configuration Cct 800 - Auto Dialler Mode - Commend C-G8-TEL Product Manual

Auto Dialler Mode

Call from Telephone to Intercom System

Initiate Call
The telephone interface can be called from any telephone in the telephone net.
After the number has been dialled, the telephone receives the "Location message".
After the location message the call has to be accepted with the defined 1- to 4-digit code (in stand-
ard "#"). Afterwards Intercom functions can be carried out, e.g. calling an Intercom station.
If "Individual Messages"
sages are switched on e.g. after start of a conversation or conversation end, at the telephone.
Cancel Conversation
The conversation is cancelled at the telephone with "#" or at the Intercom station with X.
After the conversation has been cancelled (by means of "#" or X), the connection to the Intercom
system stays upright for a configurable time. During this time, a new conversation can be built up
or other functions can be carried out in the Intercom Server.
If the telephone only hangs up and does not press "#", the conversation is automatically cancelled
after about 6 seconds.
Configuration CCT 800 – Auto Dialler Mode
Password, Switch-off Times
Select Interfaces – Telephone – TEL – Folder telephone interface – Telephone functions:
14
are configured (e.g. "Conversation to one–zero–two"), then these mes-
G8-TEL, G3-TEL
1.0/0609