Commend C-G8-TEL Product Manual page 17

G8-TEL, G3-TEL
Each of the following combo-boxes represents one of the 16 call types of the Intercom Server:
In the 16 combo-boxes (for the call types 1 – 15), the following entries can be selected:
Call 1 (Normal call)
→ The call type will be transferred via the telephone interface as "Call 1 (Normal call)"
Call 2 (Emergency call)
→ The call type will be transferred via the telephone interface as "Call 2 (Emergency call)"
Active 1
→ The call type will be transferred via the telephone interface as "Active 1"
Active 2
→ The call type will be transferred via the telephone interface as "Active 2"
Standard
→ The call type will be grouped to none of the above listed call types
Note:
For a list of the 16 call types of the Intercom Server, see current version of the manual "PRO 800"
In the example above (screenshot),
the call types 2 and 8 (of the Intercom Server) → are grouped to "Call 2 (Emergency call)"
the call types 6, 7, 11, 14 and 15 (of the Intercom Server) → are grouped to "Active 2"
This also means, if Individual Messages are configured for the call types "Call 2 (Emergency
call)" and "Active 2" , then individual messages will be put out for the call types 2, 8 resp. 6, 7, 11, 14,
15 (of the Intercom Server) –
Initiate Call
Note:
For the configuration of the following described features, see current version of the manual "PRO 800".
Call via dialling Interface
At the Intercom station, the call number of the telephone interface can be entered via the keypad of
the station e.g. by direct dialling (configuration at "Subscriber" – "Direct Dialling").
Call Request / Input Message
The telephone interface has to be configured as "central control desk" (at "Subscriber" – "Control
Desks").
For the calling station, a "call request" has to be configured to the telephone interface (at "Subscri-
ber" – "Call Request").
For a calling input, an "input message" has to be configured to the telephone interface (at "Inputs"–
"Input message").
Attention:
If the indication of input messages via buzzer is deactivated, no call is issued to the telephone (tab
"Call types" at "Inputs" – "Input message")!
If a calm down message shall be put out at the calling station after initiation of a call request, then
an appropriate configuration in CCT 800 is required
1.0/0609
see page 20.
see page 19
Auto Dialler Mode
17