Commend C-G8-TEL Product Manual page 12

Auto Dialler Mode
Take over of Call at Telephone
Call via dialling interface:
Take over of call with the defined 1- to 4-digit password (standard #).
Repeated speech messages
sage has to be listened to at least once.
Note:
If no password is defined for the take over of the call, an (optional) button has to be pressed anyhow to
be able to answer the call.
Call Request / Input Message:
Take over of call with the defined 1- to 4-digit password (standard #) + pressing button "#".
Repeated "Individual Messages"
be interrupted with "*", but each message has to be listened to at least once.
It can be defined if the telephone receives the "Dial tone" from the Intercom Server, e.g. before
taking over a call request with "#".
Cancel Conversation
The conversation is cancelled at the telephone with "#" or at the Intercom station with X.
After the conversation has been cancelled (by means of "#" or X), the connection to the Intercom
system stays upright for a configurable time. During this time, a new conversation can be built up
or other functions can be carried out in the Intercom Server.
If the telephone only hangs up and does not press "#", the conversation is automatically cancelled
after about 6 seconds.
Restart of Dialling Sequence
In case, the call is taken over by none of the configured telephone numbers of the respective dialling
sequence, 2 possibilities for restarting the sequence are available:
Reissue of Call by pressing Call Button
If a call request is not answered, then this call remains at the station and the control desk; but the tele-
phone interface is in idle mode.
By pressing the respective call button (or the input contact) once again, the dialling sequence can be
started again.
Configuration of Restart of the Dialling Sequence
Via configuration in CCT 800 it is possible, to avoid that an initiated call is not answered.
Therefore "9" has to be entered as last number of the respective dialling sequence
→ thus the dialling sequence will be started again and so forth until the call is taken over.
DIALLING SEQUENCE:
12
("Individual Messages") can be interrupted with "*", but each mes-
after taking over the call request / input message with "#", can
12121343439
Restart
Dialling Sequence
G8-TEL, G3-TEL
see page 15
1.0/0609