Table of Contents
Advertisement
If the alarm clock is on, and the current time coincides with the alarm clock
triggering time, in any of the modes and submodes of the radiometer, except for the
time and date correction mode, the alarm clock triggers and the radiometer starts
generating typical sound signals – alarm clock signals. The alarm clock symbol will
be blinking at that. The alarm clock goes off even if the radiometer is off.
The alarm clock signal can be switched off with a short press of MODE or
THRESHOLD button in any operating mode or submode of the radiometer, but for
the submodes of new threshold level values programming and the mode of
measurement results viewing. If the alarm clock signal is not disabled using the
buttons, it turns off automatically in 1 minute after triggering.
If the radiometer was off before the alarm clock goes off, the radiometer enters
the clock mode. The radiometer automatically turns off as soon as the alarm clock
signal stops ringing (in 1 min). If the user turns off the alarm clock signal before it
stops ringing, the radiometer remains on.
2.3.3.11 Mode of data communications control with the PC
95
Advertisement
Table of Contents
