Table of Contents
Advertisement
2.3.3.6.22 If you keep holding down THRESHOLD button, then during the next
four seconds the radiometer proceeds to the submode of viewing and programming
of new values of the alarm threshold level and specified limit of statistical
deviations (Figure 2.5). A stripe (1) "moving" across the instantaneous value
indicator and a blinking low-order digit (2) of a new threshold level serve as an
indication of this submode. After that release THRESHOLD button.
When a digit is blinking, it means that its value can be programmed. Use
THRESHOLD button to set the required value of the blinking digit. Successive
short presses and releases of THRESHOLD button change this value per unit. A
long press of THRESHOLD button starts automatic change of this value, which
stop after THRESHOLD button is released.
61
Advertisement
Table of Contents
