About The Ds30X Cable - Nortel Meridian 1000 Configuration Manual

Connecting the CallPilot server to the CS 1000 system

About the DS30X cable

Introduction
The MGate card (NTRB18CA) ships from the factory with the DS30X cables
required by the MPB board that is installed in the server.
.
DS30X cables supported by MPB16-4 boards
The DS30X cable that establishes the connection between the MPB16-4 boards and
the MGate cards is 10 m (30 ft) long. Therefore, the CallPilot server must be placed
within 10 m (30 ft) of the Media Gateway or Media Gateway Expansion.
IF the server is
equipped with
one MPB16-4 board
more than one MPB16-4
board
Note: The NTRH2012 and NTRH2013 cables contain ferrites that control EMC
emission levels. Do not remove them.
DS30X cable supported by the MPB96 board
The NTRH2014 cable is a triple DS30X cable that connects the first MPB96 board
to up to three MGate cards. The cable is 20 m (60 ft) long, which allows you to
install the CallPilot server in a different room from the Media Gateway or Media
Gateway Expansion.
50
CAUTION
Risk of data loss
Do not substitute other versions of these boards and cables in the
configurations specified in this documentation, as this can result in
data loss.
THEN the DS30X cable is an
NTRH2012 cable.
This is a single DS30X cable that connects one
MPB16-4 board to one MGate card.
NTRH2013 cable.
This is a dual DS30X cable that connects the first of
two MPB16-4 boards to two MGate cards. The
connectors on the NTRH2013 dual DS30X cable are
labeled DS30X-1 and DS30X-2.
Standard 1.16
CallPilot