Nortel Meridian 1000 Configuration Manual page 73

January 2007
b. Enable the route by entering the following command:
ENL ROUTE x (where x is the number assigned to the ROUTE entry)
13 Update the INET database by entering the following command:UPDATE DBS
14 Type **** and press Enter to exit the overlay.
15 Load overlay 137.
16 Type STAT ELNK and press Enter.
17 If the system displays ELNK ENABLED, then go to step 18. If the system
displays ELNK DISABLED, then do the following substeps:
a. Type ENL ELNK and press Enter.
b. Type STAT ELNK and press Enter.
c. Confirm that the system displays ELNK ENABLED. Then go to step 18.
18 Load overlay 48.
19 Type STAT ELAN and press Enter.
20 If the system displays ELAN ENABLED, then go to step 21. If the system
displays ELAN DISABLED, then do the following substeps:
a. Type ENL ELAN and press Enter.
b. Type STAT ELAN and press Enter.
c. Confirm that the system displays ELAN ENABLED. Then go to step 21.
21 Load overlay 117.
22 Verify the changes as follows:
a. Type PRT HOST and press Enter.
b. Type STAT HOST and press Enter.
c. Type PRT MASK and press Enter.
Communication Server 1000 Meridian and CallPilot Server Configuration
Configuring the CS 1000 system
73