Nortel Meridian 1000 Configuration Manual page 54

Connecting the CallPilot server to the CS 1000 system
Identifying the location of MGate #1, #2, and #3
In the cabling diagrams, the terms MGate #1, MGate #2, and MGate #3 identify the
MGate cards. MGate #1 is in the lowest-numbered slot in the Media Gateway or
Media Gateway Expansion. MGate #2 and MGate #3 are in the next available higher
slots.
One MPB16-4 board and one MGate card (32 channels or less)
Use the single cable (NTRH2012) to connect the MPB16-4 board to the MGate card.
Refer to Figure 11 on page 54.
Figure 11: MGate cabling for the 1002rp server
MPB16-4 #1
Two MPB16-4 boards and one MGate card (32 channels or less)
Use the DS30X single cable (NTRH2012) to connect the MPB16-4 #1 to the MGate
card. Refer to Figure 12 on page 55.
Note: The MPB number is identified during system startup. Therefore, you must
connect the DS30X cable to the MPB assigned the lower bus number by the
software.
54
NTRH2012
DB-25
Standard 1.16
MGate #1
G101716
CallPilot