To Test The Connection To The Nns Subnet; Testing The Connection To The Nns Subnet - Nortel Meridian 1000 Configuration Manual

Testing the CallPilot installation

Testing the connection to the NNS Subnet

Introduction
This procedure tests the network connection between the server and the Nortel
Server Subnet (NS Subnet). This applies only if CallPilot has an NNS Subnet card
and is connected to an NNS Subnet.
ATTENTION

To test the connection to the NNS Subnet

1 Click Start -> Programs -> Accessories -> Command Prompt.
Result: The Command Prompt window appears.
2 Type ping followed by the NNS Subnet IP address of another PC on the NNS
Subnet, and then press Enter.
Example: ping 255.255.255.255
Result: The display indicates a successful ping.
3 Type exit, and then press Enter to close the Command Prompt window.
130
Disconnect the NNS Subnet from the ELAN subnet before
testing to ensure that the ping is testing only the NNS Subnet.
Standard 1.16
CallPilot