40 Chapter 3 Connecting the CallPilot server to the CS 1000 system
7
8
Section B: Connecting the CallPilot server to the switch
In this section
"About the DS30X cable" (page 40)
"Connecting MPB16-4 boards to MGate cards (NTRB18CA)" (page 42)
"Connecting the MPB96 boards to MGate cards (NTRB18CA)" (page 47)
About the DS30X cable
Introduction
The MGate card (NTRB18CA) ships from the factory with the DS30X cables
required by the MPB board that is installed in the server.
Copyright © 2007, Nortel Networks
.
View the status of the LED indicators to ensure that the card is
software-enabled (red LED is OFF), and the card is operational
(green LED is ON).
Re-enable the DS0 channels that were disabled before the card
was removed.
To do this, use the Channel Monitor or the Maintenance page in
CallPilot Manager, as described in the CallPilot Server Maintenance
and Diagnostics guide for your server.
CAUTION
Risk of data loss
Do not substitute other versions of these boards and cables in
the configurations specified in this documentation, as this can
result in data loss.
Nortel CallPilot
Communication Server 1000 and CallPilot Server Configuration
NN44200-312 01.02 Standard
5.0 3 May 2007
—End—