To Verify That You Can Retrieve A Message - Nortel Meridian 1000 Configuration Manual

January 2007
Result: CallPilot plays the following prompt: Recording Stopped. There
is a brief pause, followed by the prompt: To review the
message, press 2, to send it, press 79...
12 Press 79 to send the message.
Result: CallPilot plays the following prompt: Message sent and deleted.
13 Press 83, and then hang up the phone.
14 Verify that the Message Waiting Indicator (MWI) is on.

To verify that you can retrieve a message

1 Pick up the telephone handset and dial the same Voice Messaging Service DN
again.
2 When prompted, enter the mailbox number where the message was left (for
example, 8050#).
Result: CallPilot plays the following prompt: Password?
3 Enter the mailbox password (for example, 805011#).
Result: CallPilot plays the following prompt: You have one new message.
Message one. New. From ...
ATTENTION
4 Press 2 to play the message, and then listen to it.
5 Press 76 to delete the message.
Result: CallPilot plays the following prompt: Message 1 deleted.
ATTENTION
6 Press 83 and then hang up the phone.
Verifying that each call channel and multimedia channel is functioning
properly
These tests verify that the call channels and multimedia (DSP) channels are
functioning properly.
Communication Server 1000 Meridian and CallPilot Server Configuration
If you do not hear the exact message, You have one new
message..., this indicates that the wrong prompts have been
installed or that CallPilot did not install properly.
If you did not hear the correct message, contact your Nortel
customer support representative.
If you do not hear the exact message, Message 1 deleted,
this indicates that the wrong prompts have been installed or
that CallPilot did not install properly.
If you do not hear the correct message, contact your Nortel
customer support representative.
Testing the CallPilot installation
135