Duplex Printing Cannot Be Performed Using The Paper Loaded In The Standard Tray; Part Of The Original Is Missing In The Copied Data; Part Of The Original Is Missing In The Scanned Data; The Color Mode Is Set To [Auto], But The Machine Does Not Identify Color Originals Automatically - Riso ComColor FT Series Troubleshooting Manual

Duplex printing cannot be
performed using the paper loaded
in the standard tray.
The paper type for the standard tray may have
been set to [Envelope].
When the [Thickness] setting in [Paper Type] is set
to [Envelope], duplex printing cannot be performed
using paper from the standard tray, regardless of
the type of paper that is loaded. Configure the
settings according to the paper to be used.
[Storage] - [Load] screen / [USB] - [Load] screen
select the folder
document [Change Setting] in the sub menu
[Paper Selection]
[Paper Type] [Thickness]
Part of the original is missing in
the copied data.
[Reproduction Size] may not have been set
properly.
Set the copy reproduction size to suit the
combination of the original size and paper size.
[Storage] - [Save] screen
[Change Setting] [Reproduction Size]
[Auto Reduction] may not be configured when
creating a booklet or using the [Staple / Punch]
or [Staple] setting.
When you create the booklet or staple/punch the
printed paper, the margin width you have specified
may cause the printed image not to fit on the
sheet. When [Auto Reduction] in the margin setting
is set to [ON], the printed image will be
automatically reduced to fit.
[Storage] - [Save] screen
[Change Setting] [Binding Margin] or
[Booklet] set [Auto Reduction] to [ON]
Part of the original is missing in
the scanned data.
The [Scanning Size] setting may not match the
actual size of the original.
Set [Scanning Size] to the same size as the
original, or set it to [Auto].
[Storage] - [Save] screen
[Change Setting] [Scanning Size]
[USB] - [Save] screen
[Open] select the
[Paper Tray Setting]
select the folder
select the folder
select the folder
[Scanning Size]
The color mode is set to [Auto],
but the machine does not identify
color originals automatically.
Select a color mode other than [Auto], or adjust
[Color/Black Slice Level] in the administrator
menu.
[Storage] - [Save] screen
[Change Setting] [Color Mode]
Color] / [Black] / [Cyan] / [Magenta] depending
on the purpose
^ ^
• For ComColor FT2430 users, [Cyan] is not
available. Also, select [Red] instead of
[Magenta], and select [Dual Color] instead of
[Full Color].
[USB] - [Save] screen
[Full Color] / [Grayscale] / [Black] depending on
the purpose
In the administrator menu, adjust [Color/Black
Slice Level] (1 to 5)
Setting a higher value makes it easier for the
machine to identify color originals. Contact your
administrator for details.
ComColor FT Series Troubleshooting Guide
select the folder
select [Full
[Color Mode] select
2
43