Riso ComColor FT Series Troubleshooting Manual page 19

Message
The staple unit (punch unit, top
tray unit, stacking tray unit,
booklet tray unit, tri-fold output
tray unit) of the finisher is not
connected. Check. (The job was
deleted.)
Failed to lower the Stacking Tray.
Check the tray of the finisher.
Job name:
Cannot print due to failure of the
staple unit (punch unit, top tray,
stacking tray, booklet unit, tri-fold
output tray) of the finisher.
Printing without using the staple
unit (punch unit, top tray,
stacking tray, booklet unit, tri-fold
output tray) is possible. (The job
was deleted.)
Job name:
Paper size that cannot be output
with the Z-fold setting is included.
Check the print data. (The job
was deleted.)
This paper size cannot be output
with the current paper fold
setting. Check the orientation or
settings of the set paper.
This paper size cannot be output
with the current booklet setting.
Check the orientation or settings
of the set paper.
This paper size cannot be output
with the current staple/punch
setting. Check the orientation or
settings of the set paper.
Action to Take
Each unit (staple unit, punch unit, top tray unit, stacking tray unit,
booklet tray unit, tri-fold output tray unit) of the multifunction finisher
is not connected. Contact your dealer or authorized service
representative.
Something may be obstructing the stacking tray. Make sure that
nothing is placed below or near the tray.
The staple unit, punch unit, top tray unit, stacking tray unit, booklet
unit, or tri-fold output tray unit of the multifunction finisher cannot be
used. Contact your dealer or authorized service representative. If you
touch [Close], you can continue using the machine except for the unit
that has an error.
The original contains the page whose paper size is not compatible
with [Mixed Size Z-fold]. The combinations of paper sizes that
enabled [Mixed Size Z-fold] are only A4 and A3 paper, B5 and B4
paper, and Letter-R and Ledger paper. Check the original size.
Touch [Close], and change the settings.
For more information on the paper sizes and orientations that can be
used when folding the paper, see "Fold" or "Booklet Binding" in the
"User's Guide".
Touch [Close], and change the settings. For more information on the
paper sizes and orientations that can be used when creating
booklets, see "Booklet" in the "User's Guide".
Touch [Close], and change the settings. For more information on the
paper sizes and orientations that can be used when stapling, see the
following.
• When using the face down finisher
"Staple" of the "User's Guide"
• When using the multifunction finisher
"Staple/Punch" of the "User's Guide"
ComColor FT Series Troubleshooting Guide
1
17