Table of Contents
Advertisement
Replacement Procedure
Angle (Fan Assembly) Replacement
Angle (Fan Assembly) Replacement
Tools Required
•
•
•
Removal Procedure
Refer to Figure 4-18 for this procedure.
Step 1. Remove the Outer Cover as described in "Outer Cover Replacement" on page 54.
Step 2. Remove the Fan Assembly as described in "Fan Assembly Replacement" on page 86.
Step 3. Remove the two TORX T10 screws (item 1) fastening the Angle for Fan Assembly.
Step 4. Lift the Angle (item 2).
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
NOTE
Set a torque to 9 in-lb for torque driver when fasten the TORX T10 screws (item 1).
Figure 4-18
Angle (for Fan Assembly) Removal
88
torque screwdriver, T15 and T20
torque screwdriver, T10 (set to 9 in-lb)
box torque wrench, 9/16 inch
Chapter 4
Advertisement
Table of Contents
Troubleshooting
