Table of Contents
Advertisement
Replacement Procedure
Hard Disk Assembly Replacement (Option 020)
Hard Disk Assembly Replacement (Option 020)
Tools Required
•
•
Removal Procedure
Refer to Figure 4-3 for this procedure.
Step 1. Remove the four TORX T10 screws (item 1) fastening the Hard Disk Assembly.
Step 2. Slide out the Hard Disk Assembly.
Step 3. Disconnect the power supply cable (item 2) from the Hard Disk Drive.
Step 4. Disconnect the S-ATA cable (item 3) from the Hard Disk Drive.
Step 5. Remove the four TORX T10 screws (item 4) fastening the Hard Disk Drive.
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
NOTE
Set a torque to 9 in-lb for torque driver when fasten the TORX T10 screws (item 1).
Set a torque to 4.4 in-lb for torque driver when fasten the TORX T10 screws (item 4).
60
torque screwdriver, T15, and T20
torque screwdriver, T10 (set to 4.4 in-lb, and 9 in-lb)
Chapter 4
Advertisement
Table of Contents
Troubleshooting
