Agilent Technologies E5061B Service Manual page 108

Table 5-2 Post-Repair Procedures
Replaced Required Adjustments
Assembly or Correction Constants (CC)
Part
A11 Source Perform the following required
Module
adjustments using "A11 Source Module"
in Spot Adjustment of the program.
A3/A4 Receiver Perform the following required
adjustments using "A3/A4 Receiver
Module
Module" in Spot Adjustment of the
program.
A10 Analog No adjustment needed
Motherboard
A50 CPU No adjustment needed
module
DSP Card Perform the following required
adjustments using "DSP board" in Spot
Adjustment of the program.
Writing ID
Front Panel Board No adjustment needed
Handler I/O No adjustment needed
Board
Chapter 5
Post-Repair Procedures
Post-Repair Procedures
Verification
"To Execute the Diagnostic Test" on page 31
Frequency Accuracy Test
RF Output Level Accuracy Test
RF Output Level Linearity Test
Crosstalk & System Dynamic Range Test
Noise Floor Test
Trace Noise Test
Dynamic Accuracy Test
Compression Test
IF Linearity at 1.195 GHz Test
IF Linearity at LF Test
Uncorrected System Performance Test.
"To Execute the Diagnostic Test" on page 31
Frequency Accuracy Test
RF Output Level Accuracy Test
RF Output Level Linearity Test
Crosstalk & System Dynamic Range Test
Noise Floor Test
Trace Noise Test
Dynamic Accuracy Test
Compression Test
IF Linearity at 1.195 GHz Test
IF Linearity at LF Test
Uncorrected System Performance Test.
Inspect the Booting Process
When the symptom of failure is out of
specification, perform the performance test.
Inspect the Booting Process
Inspect the Booting Process
Executed all of the performance test.
"To Check the Front Panel" on page 38
"To Check the External Trigger Input" on
page 41
"To Check the Front Panel" on page 38
"To Execute the Diagnostic Test" on page 31
107