Barbecue Island Assembly; Unit Attachment; Stucco And Tile Application - Cal Flame MC800 Owner's Manual

Barbecue Island Assembly

Unit Attachment

1. Place the island sections together on the ground.
Make sure the ground where the barbecue is placed
is as level as possible for best alignment.
NOTE: If the ground is not level, use shims to level out
the island sections. This needs to be done before you
intall the bolts.
Connect the speakers, lights, and main power cables
2.
before sliding the sections together.
Insert the bolts through the pre-drilled holes from the
3.
inside of the barbecue island (total of four bolts on
each side).
2008 Barbecue Island Owner's Manual
LTR20081036, Rev. A
Tighten all bolts using a 9/16" wrench.
3.

Stucco and Tile Application

Prepare and fill the gap or seam line with speed
1.
set.
Using your fingertips, push and flatten out the speed
2.
set into the seam line.
NOTE: Allow the speed set to dry before proceeding
with the next step.
Using a small brush or hopper gun, apply stucco to
3.
the seam line.
4. Mix grout with water in a container.
5. Fill the tile seam line with grout using a small spatula
or your finger.
Clean the grout with a damp rag.
6.
7. Let the grout and stucco dry for at least three
hours.
Assembly
Page 3