Installing Grills In Barbecue Islands; Installing Barbecue Cart End Shelves - Cal Flame BBQ08870P Owner's Manual

Installation / Assembly
Installing Grills in Barbecue
Islands
You will need a second person to help you to avoid
damaging the grill, the transformer, or your barbecue
island .
Before installing a grill or side burner in any island or cut
out, make sure that the opening is not bigger than the
outside frame of the grill unit. The grill should rest on
the lip of the frame. For drop-in accessories, adequate
cross ventilation must be designed into enclosure to
ensure the drop-in grill or side burner does not become
overheated.
Pay careful attention to the location of gas lines. Gas
lines should be routed away from sources of heat and
should make as few bends as possible.
Check to see if gas line connections will be accessible
when grill is installed.
• If gas line connections are not easily accessible
when the grill is installed, support the grill above
counter level and attach the gas lines to the grill.
When the gas connections are made, slide the grill
into the cut out.
• If gas line connections are accessible when the grill
is installed, slide the grill into the cut out and then
attach the gas lines.
Be very careful not to kink gas lines when lowering the
grill or side burner into the cut out.
Keep your fingers away from where the grill will be
supported on counter.
trapped and serious injury could occur.
Check to make sure the grill is level and is supported
around the entire outside edge. If the grill is not level
or is unstable, use non-combustible shims under the
outside lip to stabilize it.
Perform the leak test procedure as described earlier in
this manual.
Page 10
Your fingers could become
Installing Barbecue Cart End
Shelves
1. Prepare the installation of handle: 2 hex screws, 2
washers
2. Use finger to thread the hex screws and washers
into the threads on both ends of the handle.
3. Use ratchet to tighten the hex screws on both ends.
The handle has been installed onto the shelf.
4. Take the three screws off on both sides of the cart to
install the mounting bracket.
5. Install the mounting brackets on both sides. Make
sure the mounting brackets are in the correct
orientation. Two mounting brackets have been
installed onto the cart.
6. Slides the shelf into the brackets from bottom.
7. Make sure to slide into the brackets on both side
evenly.
8. Slide the shelf fully onto the mounting brackets.
9. Lift and rotate the shelf so it slide back into the
brackets.
10. Keep the shelf in the normal open position.
11. Prepare to install stop brackets under the mounting
brackets on both sides.
12. Remove one screw and loose the other screw so the
stop bracket can be placed as shown. Tighten both
screw to hold the stop bracket.
2008 Barbecue Grill and Cart Owner's Manual
LTR20081038, Rev. A