Before You Begin Installation; Power Disconnect Device; Installation Requirements - ETC ArcSystem Pro Multi-Cell RDM Manual

ETC Installation Guide
ArcSystem Pro Multi-Cell

Before You Begin Installation

Review the following sections before beginning your ArcSystem installation. ArcSystem products
should only be installed by a qualified installer or electrician.

Power Disconnect Device

Before installation, make sure you have a main circuit breaker cabinet or other readily accessible
input power disconnect device installed ahead of your ArcSystem products.
WARNING:
system before installation, maintenance, cleaning, or any other system modification could
result in serious injury or death.
AVERTISSEMENT :
débrancher toutes les sources d'alimentation du système avant l'installation, l'entretien, le
nettoyage ou toute autre modification du système peut causer des blessures graves ou la
mort.
De-energize main feed to ArcSystem and follow appropriate Lockout/Tagout procedures as
mandated by NFPA 70E. It is important to note that electrical equipment such as breaker
panels can present an arc flash hazard if improperly serviced. This is due to the high
amounts of short-circuit current available on the electrical supply to this equipment. Any
work must comply with OSHA Safe Working Practices.
WARNING:
cannot be serviced or operated safely.
AVERTISSEMENT :
qu'un dispositif de déconnexion de l'alimentation ne soit accessible.

Installation Requirements

Indoor installation only: 0–40°C (32–104°F), 5–95% non-condensing humidity.
Dry locations only.
Installation location must support the weight of the fixture and applicable mounting hardware.
CAUTION:
air flow. Enclosing the fixtures or drivers temporarily or permanently may cause damage to
the fixtures or drivers.
ArcSystem Pro Multi-Cell
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all power to the
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE! Négliger de
Circuits that are installed without an accessible power disconnect device
Il est imprudent d'utiliser ou de réparer les circuits installés sans
ArcSystem fixtures and drivers are not suitable for use in spaces with restricted
Page 7 of 24 ETC