Chain Program - VETRON 5390 Instruction Manual

NR. PARAMETER
» END BACKTACK
D Stitch lenght
145
146 CD speed
NR. PARAMETER
» SEAM END
150 Thread trimming
Trim stitch tension
153
(Only for Sub Class -11)
Reserved
157
(Only for Sub Class -11)
158 Trim stitches
159 Trim stitch length
160 Backturn
NR. PARAMETER
»

CHAIN PROGRAM

999 Chain program
DESCRIPTION
You can choose between:
STD = Stitch length for B in backtack same as length set in parameter 010
(Main stitch length).
4.0 mm = Stitch length for B in backtack can be choosen irrespectiv of the
main stitch length (parameter 010) (e.g. 4.0 mm).
-4.0 mm = When the stitch length for B in backtack is entered in the
minus range this part of the back tack will done in reverse.
800 S/min = Can be set between 50 – 2000 S/min (e.g. 800 S/min)
DESCRIPTION
You can choose between:
OFF = Thread trimmer is inactive.
ON = Thread trimmer is active.
You can choose between:
-1 = Thread tension by trimming
0-100% = Thread tension released
Thread tension value
Thread trimming tension, adjustable:
-2 = the same thread trimming tension as the sewing thread tension
-1 = released thread tension
0-100 = thread trimming tension in %
Extra stitches before thread trimming, released by trimming.
Adjustable between OFF and 100 stitches
Stitch length setting for the setted trim stitch.
You can choose between:
OFF = Backturn is inactive.
ON = Backturn is active.
DESCRIPTION
This parameter will show if a progam is used in a chain program.
INFO!
A chain program will be used when di erent operations on a work piece
are done one after the other. The machine will set itself automatically for
the next work step.
VETRON 5390 - POST BED MACHINE - INSTRUCTION BOOK
05. PROGRAMMING
04. PROGRAM PARAMETER
-14-14
07/2018
49