Firmware Update Error - VETRON 5390 Instruction Manual

07. ERROR CODES
02. ERROR MESSAGES
-1-3
ERROR CODE DESCRIPTION
503 Footlifter overcurrent
504 Footlifter not connected
603 TensionA overcurrent
604 TensionA not connected
610 Stepper driver FG Init error
690 Stepper driver FG software incompatible
703 Edge guide / Puller lift stepper overcurrent
704 Edge guide / Puller lift stepper not connected
Edge guide / Puller lift switch
714
endposition not reached
Edge guide / Puller lift switch
724
not connected or motor is blocked in init position
» HEAD PCB ERROR
800 Head PCB connection lost
805 Head PCB EEPROM error
810 Head PCB init error
890 Head PCB software incompatible
» FIRMWARE UPDATE ERROR
2004 no udisk
2008 no type info
07/2018
70
VETRON 5390 - POST BED MACHINE - INSTRUCTION BOOK
SOLUTION
» Check connector and cable S4
» Measure resistance of the coils
» Replace motor
» Replace control box
» Check connector and cable S5
» Measure resistance of the coils
» Replace motor
» Replace control box
Apply latest software update. If a timeout during
update occurs, replace control box
Apply latest software update
» Check connector and cable S6
» Measure resistance of the coils
» Replace motor
» Replace control box
» Check connector and cable of the end switch
» Check if the end position can be reached manually
» Measure end switch function
Check connector and cable B1
Replace HeadPCB
Apply latest software update. If a timeout during
update occurs, replace Head PCB
Apply latest software update
Try another USB stick.
Only use USB sticks recommended by VETRON
» Check the folder structure on the USB stick
» Copy the firmware data to your USB stick again