VETRON 5390 Instruction Manual page 46

05. PROGRAMMING
04. PROGRAM PARAMETER
-9-14
5
NR. PARAMETER
» ALLOCATION OF HOTKEYS
085
086 Handwheel function (
087 Knee switch function
07/2018
44
VETRON 5390 - POST BED MACHINE - INSTRUCTION BOOK
DESCRIPTION
TENSSW
TENSTG
NEEDLE
TARGET
SCENTER
TACKTYPE
POST BED
PULLER
Same functions as parameter 085, when the electronic handwheel is pushed
)
1
You have the same function as parameter 085, when the knee switch is pushed.
= Thread tension switch from A1 to A2 for this program. (By press-
ing and holding the key you will switch to the 2
as you hold the key. You will go back to the 1
releasing the button) (also for two-needle machines B1and B2).
= Thread tension switch from A1 to A2 for this program. (By press-
ing the key you will switch to the 2
it will switch back to the 1
machines B1to B2).
= By pressing the key the machine will switch to the 2
position (needle up). By pressing it again it will switch back to
the 1 position (needle down).
st
= By pressing the key the machine will go to the target stitch posi-
tion. Needle point just above the material.
(Target stitch position parameter 078).
= By the machines with two-Needles, this signal for seam middle
guide can be switched o .
= With this funktion you can switch in the seam between stitch in
stitch and normal back tack.
= By pressing the key the post bed can be moved in or out.
= By pressing the key the puller wheel can be moved up or down
1
4
2
3
tension as long
nd
tension setting by
st
nd tension. By pressing it again
tension setting. (also for two-needle
st
nd
needle
.
1