VETRON 5390 Instruction Manual page 44

05. PROGRAMMING
04. PROGRAM PARAMETER
-7-14
NR. PARAMETER
» ELECTRONIC RULER FOR EDGE DISTANCE (OPTIONAL)
Edge value
060
066 Edge guide hight adjustment
NR. PARAMETER
» PRESSER FOOT HEIGHT, PRESSER FOOT POSITION, NEEDLE POSITION
070 Foot lift height
071 Foot lift maximum for operator
074 Foot position on stop
075 Foot position on seam end
077 Needle position on stop
NR. PARAMETER
» TARGET STITCH FUNCTION
078 Target stitch position
07/2018
42
VETRON 5390 - POST BED MACHINE - INSTRUCTION BOOK
DESCRIPTION
Following functions are available:
OFF = Edge ruler is deactivated.
0.1–35.0 mm = Edge ruler is activated (Edge distance e.g. 10 mm).
The distance from the needle to the edge can be entered directly in mm. It can´t
be set below the right edge of the presser foot. This setting can only be done by
a service technican.
The setting for the desired hight of the 2-axial edge guide is entered here in %.
DESCRIPTION
The setting for the desired hight of presser foot lift is entered here (in mm)
for the program in question.
You can restrict he maximum foot heigth (mm) for the operator here.
Two positions are available (Pedal in 0-position):
UP or DOWN.
Two positions are available (Pedal in 0-position):
UP or DOWN.
Two positions are available (Pedal in 0-position):
POS1 or POS2.
DESCRIPTION
INFO!
Parameter 078 can only be selected when the position of stitch placing
is activated in parameter 085, 086 or 087. The position of the needle
point above the material will be set with this parameter.
1
4
2
3