Sensor State; Parameter Reset; Plant Diagram - Siemens Albatros RVS46 Series User Manual

Sensor state

Parameter reset

Plant diagram

RVS46.543 only
Structure of control
number
Operating
line
BZ6212
BZ6215
BZ6217
Check-No. heat source 1
Check-No. storage tank
Siemens
Building Technologies
Line no. Operating line
6200 Save sensors
At midnight, the basic unit stores the states at the sensor terminals.
If, after storage, a sensor fails, the basic unit generates an error message.
This setting is used to ensure immediate saving of the sensors. This becomes a
requirement when, for instance, a sensor is removed because it is no longer needed.
Line no. Operating line
6205 Reset to default parameters
All parameters can be set to their default values. Exempted from this are the following
Time of day and date , operator unit , radio and all time programs ,
operating pages:
as well the s etpoint manual control .
Line no. Operating line
6212 Check-No. heat source 1
6215 Check-No. storage tank
6217 Check-No. heating circuits
To identify the current plant diagram, the basic unit generates a check number.
The check number is made up of the lined up part diagram numbers.
Every control number consists of 3 columns, each representing the application of a
plant component. Every column shows a number with a maximum of 2 digits. Exception
is the first column. If the first digit in the first column is a 0, the 0 will be hidden.
First column
2 digits
Heating circuit P
User Manual
Configuration
Second column
2 digits
Solar
Heating circuit 2
Solar
0 No solar
1 Solar with collector sensor
and pump
Third column
2 digits
DHW storage tank
Heating circuit 1
Oil / gas boiler
00 No boiler
DHW storage tank
0 No DHW storage tank
1 electric immersion heater
2 Solar connection
4 Charging pump
5 Charging pump, solar
connection
13 Diverting valve
14 Diverting valve, solar
connection
105/138
CE1U2353en
2014-07-30